Home >
Appendix
>
Auto Media Configuration Overview
Auto Media Configuration allows the printer to automatically detect the characteristics of the installed paper, and
then select the correct paper size settings.
Model
TD-4210D/TD-4410D
TD-4420DN/TD-4520DN •
Auto Media Configuration Workflow
After Auto Media Configuration is started, the printer will feed the paper to detect its characteristics. By default,
the printer uses the continuous feed setting unless:
•
The transmissive/gap sensor detects a die-cut label.
•
The reflective/black mark sensor detects marked media.
•
If the paper runs out during the Auto Media Configuration, the printer will not detect the media type
successfully and an error will be displayed.
•
If the paper width is not aligned correctly, the calibration will not be successful.
•
Depending on the paper's shape and material, media detection may not be possible.
•
(TD-4210D/TD-4410D)
The recently used paper width is set.
•
(TD-4420DN/TD-4520DN)
The paper width is obtained by subtracting 2.0 mm from the left and right from the detected width.
Related Information
•
Auto Media Configuration
It may be necessary to feed the paper again depending on the results.
1
Auto Media Configuration
Automatic Detection Items
•
Paper type
•
Length
•
Label spacing
•
Width of marks
•
Gap/Black mark detection sensitivity
Paper type
•
Width
•
Length
•
Label spacing
•
Width of marks
•
Gap/Black mark detection sensitivity
> Auto Media Configuration Overview
1
117