Samsung Q7FAM Series E-Manual page 110

The problem
The Broadcasting function
has been deactivated.
There is an intermittent loss
of audio or video.
There are small particles on
the TV's bezel.
The settings are lost after
5 minutes or every time the
TV is turned off.
A POP (TV's internal banner
ad) appears on the screen.
The TV is making a popping
noise.
The TV is making a
humming noise.
Broadcasting is only available when the
Broadcasting cannot be accessed while you watch TV using a cable or satellite box.
Broadcasting cannot be accessed while a recording is in progress or the Timeshift function
is running.
Check the cable connections and reconnect them.
Loss of audio or video can be caused by using overly rigid or thick cables.
Make sure the cables are flexible enough for long term use. If you are mounting the TV to a
wall, we recommend using cables with 90-degree connectors.
This is part of the product's design and is not a defect.
If Usage Mode is set to Retail
reset every 5 minutes.
Change Usage Mode (
Home Mode.
Change Usage Mode (
Home Mode.
The expansion and contraction of the TV's outer casing may cause a popping noise. This does
not indicate a product malfunction. The TV is safe to use.
Your TV utilises high-speed switching circuits and high levels of electrical current.
Depending on the TV's brightness level, the TV may seem slightly noisier than a
conventional TV.
Your TV has undergone strict quality control procedures that meet our demanding
performance and reliability requirements.
Some noise coming from the TV is considered normal and is not an acceptable cause for an
exchange or refund.
Try this!
Source is set to TV.
Mode, the TV's audio and video settings are automatically
Settings General
Settings General
- 104 -
System Manager Usage
System Manager Usage
Mode) to
Mode) to