Fig. 57: Fitting The Wall Insert; Table 42: Tightening Torque (72011) - ABB HT588465 Original Operation Manual

Operation Manual / 4 Product description / A100-M axial
8 Disassembly and assembly / 8.10 Installing the compressor casing
Fitting the wall insert
Fig. 57: Fitting the wall insert
Part number A170-M A175-M
72011 M20 M24
580 Nm 1000 Nm
Table 42: Tightening torque (72011)
1. Remove lifting device (90190/90195).
2. Slide wall insert (77000) into compressor casing up to stop and remove guide stud
(90319).
3. Secure wall insert with screws (72011) and washers (72008).
For assembly of the alternative air inlet, see section Removing / Installing air-inlets →59.
© Copyright 2019 ABB. All rights reserved. HZTL4033_DE Revision C February 2019