Installing The Compressor Casing; Fig. 54: Installing The Compressor Casing; Table 40: Tightening Torque (61037 / 61090) - ABB HT588465 Original Operation Manual

Operation Manual / 4 Product description / A100-M axial
8 Disassembly and assembly / 8.10 Installing the compressor casing
8.10

Installing the compressor casing

Installing the compressor casing external part
Fig. 54: Installing the compressor casing
Part number
61037
61037 (nuts that are difficult to ac-
cess)
61090
Table 40: Tightening torque (61037 / 61090)
1. Distributed evenly around the circumference, screw the press-off nuts (61090) onto the
studs of the bearing casing and turn them by hand until they are at the end of the thread.
2. Grease the new O-ring (42012) and fit it.
3. Fasten lifting device (90190 / 90195) to compressor casing (72000) and secure to crane.
4. Position the compressor casing (72000).
Tighten nuts (61037) crosswise.
5. Remove lifting device (90190 / 90195).
6. Tighten the three press-off nuts (61090) against compressor casing (72000) by applying
the corresponding tightening torque.
© Copyright 2019 ABB. All rights reserved.
A170-M
M22
415 Nm
Pre-tightening torque 30 Nm
Tightening angle 45° ±5°
M22
50 Nm
HZTL4033_DE
A175-M
M24
490 Nm
Pre-tightening torque 40 Nm
Tightening angle 45° ±5°
M24
50 Nm
Revision C February 2019