Product Operation; Installation; Appliance Charging - Samsung VR5000 Instruction Manual

Product Operation

Caution
1. Do not use your robot on wet surfaces or surfaces with standing water. Before using the
product on a rug with tasseled edges,please fold the rug edges under.
2. It may be necessary to place a physical barrier at the edge of a drop to stop the unit from
falling over the edge.
3. Remove power cords and small objects from the floor that the robot could be obstructed
by, and tidy up the area to be cleaned by putting furniture, such as chairs, in their proper
place.
robot works regurally.
10
，etc. to make sure the

Installation

Push the side brush directly into the conver
shaft of the base of side brush.

Appliance Charging

1
Put the docking station well：Place the
docking station against a wall and remove
all of obstructions around the docking
stand, as shown in the figure below.
3
Place the appliance on the docking station, as shown in the pic.
Caution
a. When charging, white light of button flashes at intervals of two seconds;
b. When the charging is completed, the white light of button is always on;
c. When the battery is low power in standby mode, and the red light flashes;
d. When the battery is low power in the working mode, the appliance will automatically find the
docking station for charging;
e. When charging, empty the water tank and remove the mop attachment.
Please remove a "White bumper gasket"
before using.
Remove it
before using
2
Switch the power on after open
the cover.
11