Table of Contents
Advertisement
H O W T O U S E
USING THE CONTROLS
AUTO CLEAN
•
To turn the AUTO CLEAN function on, press
the AUTO CLEAN button while the air
set each time you wish to run the AUTO CLEAN
function.
AUTO CLEAN is used to remove moisture from
the heat exchange coils. This helps prevent the
formation of mildew and odors.
To use AUTO CLEAN
1
With the air conditioner running in COOL,
DRY or ENERGY SAVER mode, press the
AUTO CLEAN button.
2
AUTO CLEAN will be displayed in the
LED diplay.
Press the POWER button to turn the air
conditioner off. AUTO CLEAN will run
the circulation and exhaust fans with the
compressor off for a few minutes after
the power is turned off.
To cancel AUTO CLEAN, or to stop an
AUTO CLEAN cycle in process, simply press
the AUTO CLEAN button again. The
AUTO CLEAN function will not operate if the
air conditioner is already off.
14
conditioner is running in COOL,
DRY, or ENERGY SAVER mode.
This function can only be selected
from the remote; it is not available
from the control panel. It must be
AUTO SWING
AUTO SWING function can only be activated
with the remote. When this function is on, the
air discharge will oscillate to
circulate air more evenly
through the room. To turn this
function off, simply press the
AUTO SWING button with the
remote again.
With AUTO SWING off, you may also manually
adjust the air discharge to the desired position.
It will maintain this position until the air
conditioner is turned off or AUTO SWING is
activated.
When the displayed temperature
is °C (or °F), you can press this
button to swith to °F (or °C).
Advertisement
Table of Contents
