Oven Racks - GE PT9050 Owner's Manual

Direct air convection built-in electric wall oven
Hide thumbs Also See for PT9050:
Table of Contents

Advertisement

Available languages

Available languages

Oven Racks

Your oven has six rack positions. Recommended rack
positions for various types of foods are provided in the
Cooking Guide. Adjusting rack position is one way to
impact cooking results. For example, if you would prefer
darker tops on cakes, muffins, or cookies, try moving
brown on top try moving them down next time.
sufficient space for air to flow.
Oven Racks
Your oven may have extension racks and/or traditional
flat racks.
To avoid possible burns, place the racks in the desired
position before you turn the oven on.
Extension Racks
Extension racks have an install feature that locks into the
rack supports (guides) on both sides. Once the install
feature is locked into place, always pull the rack out,
by its upper front rail, to its full extension stop position,
when placing or removing cookware.
racks with the graphite lubricant provided with your
oven. Remove the rack from the oven, remove debris in
the slide tracks with a paper towel, shake the graphite
lubricant and place 4 small drops on the two bottom
tracks of the left and right sides. Open and close the
rack several times to distribute the lubricant.
To order additional graphite lubricant, read the
Assistance and Accessories section at the beginning of
this manual.
To Remove An Extension Rack:
1. Make sure the rack is pushed all the way into the
oven.
2. Grasp the rack by both its upper front rail and its
lower handles on two sides and lift straight up to
unlock the rack from the rack supports.
3. Firmly holding onto both the upper front rail and lower
handles on both sides, pull the rack forward. Grasp the
rack on both sides if necessary. Then remove it from
the oven.
To Replace An Extension Rack:
1. Place the rear portion of the rack onto the rack
supports (guides) as shown in the picture.
2. Hold the upper front rail and lower handles and push
the rack all the way in until the install feature locks
into the front rack support.
on the rack slides.
49-80754-2
Handle
Handle
from the rack
support
Hold the upper front rail and
lower handles and push the rack
all the way in until the install fea-
ture locks on the front support
The oven
has 6 rack
positions
Handle
Handle
Front Rack
13

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Pt7050Ct9050Pt7550Pt9550Ct9550Pt7fmds ... Show all

Table of Contents