Asus PRIME H110M-P Manual page 11

DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
USB 3.0 connector (20-1 pin USB3_12)
Connect a USB 3.0 module to this connector for additional USB 3.0 front or rear
panel ports. This connector complies with USB 3.0 specifications and provides
faster data transfer speeds of up to 5 Gbps, faster charging time for USB-
chargeable devices, optimized power efficiency, and backward compatibility with
USB 2.0
Intel H110 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
USB 2.0 connector (10-1 pin USB78, USB910)
Connect a USB module cable to this connector, then install the module to a slot
opening at the back of the system chassis. This USB connector complies with
USB 2.0 specifications and supports up to 480Mbps connection speed.
Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end of
the front panel audio I/O module cable to this connector.
ASUS PRIME H110M-P
For more details, refer to System memory.
• We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard's high-definition
audio capability.
• If you want to connect a high-definition front panel audio module to
this connector, set the Front Panel Type item in the BIOS setup to [HD
Audio]. If you want to connect an AC'97 front panel audio module to this
connector, set the item to [AC97]. By default, this connector is set to [HD
Audio].
F_PANEL
+PWR_LED- PWR BTN
PIN 1
+HDD_LED- RESET
1-3