Installation; Positioning; Levelling; Start-Up - Gastro-Cool 135101 Instructions For Use Manual

6 Installation

6.1 Positioning

The appliance should be located in a well ventilated and dry room. The ambient
temperature affects the power consumption and correct function of the
appliance.
Sufficient air circulation on the rear wall and upper edge of the appliance
must be guaranteed. For optimal ventilation of the appliance the minimum
ventilation crossections must be observed: i.e. position the refrigerator at least
100 mm away from the wall, and furthermore a space of 20 mm must be left
to the right and to the left, and 300 mm at the top. Use the appliance on a firm
and smooth surface.
IMPORTANT
• The appliance must not be exposed to direct solar radiation.
• The appliance must not stand on heating elements, next to a stove or
other heat sources.
• The appliance must be positioned so that the mains plug is accessible.
• The appliance may only stand in a location where the ambient temperature
corresponds to the climate classification for which the appliance is designed.
This unit is designed to operate in climates where the maximum temperature
ranges from 16 to 32 °C and the maximum humidity is 70%.
6.2

Levelling

If the bearing surface is uneven the appliance can be balanced with the front feet.
Turn the foot (34) until the appliance stands firmly on the ground horizontally and
without wobbling.
34
30
7

Start-up

7.1 Before starting up for the first time
After transportation the appliance should be left to stand for at least 24 hours
so that the coolant can separate from the appliance oil and collect in the
compressor. Non-observance of this may damage the compressor and so lead to
the appliance malfunctioning. In such a case the warranty becomes invalid.
Clean the interior of the refrigerator and all of the accessories to be found
here with commercially available, mild cleaning products.
WARNING: Do not store explosive substances such as aerosol
!
cans with a flammable propellant in this appliance.
CAUTION: Please take care that the bottom of appliance is not completely
covered by bottles in order that the condensation drain is not disrupted.
It is best to put the bottles on a shelf.
The shelf can withstand the maximum load 12 kg.
7.2 Connecting the appliance to the mains supply
IMPORTANT
It is imperative that the appliance be earthed according to the directions. For
this purpose the plug of the connecting cable is provided with the appropriate
contact.
IMPORTANT
Call a specialist electrician if the plug does not fit into the socket. Do not try
to force the plug into the socket.
IMPORTANT
If you disconnect the appliance from the mains supply, or if a power cut
occurs: wait for 5 minutes before you restart the appliance.
31