Controls - GE AEW05 Owner's Manual And Installation Instructions

About the controls on the air conditioner.
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Light indicates the unit is in the
temperature or delay time Set mode.
8
NOTE: The display always shows the room temperature except
when setting the Set temperature or the Delay timer.
Air Conditioner Controls

Controls

1. Power Pad
Turns air conditioner on and off. When turned on, the display
will show the room temperature.
2. Display
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting the
temperature in Cool or Energy Saver modes. The Set light will
turn on while setting.
3. Temp Increase + /Decrease – Pads
Use to set temperature when in Cool or Energy Saver mode.
The Set light will turn on while setting.
4. Delay Timer Increase + /Decrease – Pads
Each touch of the Increase
+
or the Increase / Decrease
will set the delay time when using the Delay 1–24hr timer. The
Set light will turn on while setting.
5. Fan Speed Pads
Use to set the fan speed to Low, Med, High or Auto on the
unit. NOTE: On the remote control, use the fan speed Increase
+ –
/ Decrease pads to set the fan speeds to Low, Med or
High. Use the Auto pad to turn Auto fan on.
6. Mode Pad
Use to set the air conditioner to Cool, Energy Saver or Fan
Only mode.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to degree Celcius (°C), press
+
the Temp Increase and Temp Decrease
Fahrenheit (°F)
4
Set
Temp / Delay
+
-
Filter Delay
Check 1-24 Hrs
Auto
Cool
High
Fan Only
Med
Energy Saver
Low
Fan
Mode
Speed
Power
+ –
/ Decrease pads on the unit
–
pads on the remote control
–
buttons together and hold for 3 seconds. Repeat the process to change back to degree
Light indicates the
delay timer is set.
Delay 1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
7. Delay Pads/Delay 1-24hr Pad
When the air conditioner is off, it can be set to
automatically come on in 1 to 24 hours at its previous mode
and fan settings.
When the air conditioner is on, it can be set to
automatically turn off in 1 to 24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the Delay pad on
the remote control. Each touch of the Increase
–
Decrease pads on the unit or the Increase
–
Decrease pads on the remote control will set the timer in
1-hour intervals. The Set light will turn on while setting.
To review the remaining time on the Delay 1–24hr timer,
press the Delay 1–24hr pad on the unit or the Delay pad on
the remote control. Use the Increase
the unit or the Increase
control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad until the light
on the Delay 1–24hr pad goes off.
8. Reset Filter
LED will turn on when fan has accumulated 250 hours of run
time as a reminder to clean filter. Press Reset Filter to turn off
the LED and reset the accumulated run time.
Fan Fan
Remote Control
+
+
/
+
/ Decrease
+ –
/ Decrease pads on the remote
Delay
timer
Increase
Auto Fan
on
Fan speed
Increase
Unit power
on/off
/
–
pads on