Sony SHOWVIEW SLV-D950B Operating Instructions Manual page 64

• Audio DRC (Dynamic Range Control)
Makes the sound clear when the volume is turned down when playing a DVD that
conforms to "Audio DRC". This affects the output from the following jacks:
– OUT AUDIO L/R jacks
– DIGITAL AUDIO OUT (OPTICAL or COAXIAL) jack only when "Dolby
Digital" is set to "D-PCM".
The default setting is indicated in bold print.
Standard
TV
• 48kHz/96kHz PCM
Selects the sampling frequency of the audio signal.
The default setting is indicated in bold print.
48kHz/16bit
96kHz/24bit
Notes
• If you select the surround setting while playing a DVD, the player does not output the
following signals from the DIGITAL AUDIO OUT (OPTICAL or COAXIAL) jack.
– Dolby Digital signals (when you set "Dolby Digial" to "D-PCM" in "OPTIONS AUDIO"
menu)
– MPEG audio signals
• If you connect a component that does not conform to the selected audio signal, a loud noise
(or no sound) will come out from the speakers, affecting your ears or causing the speakers to
be damaged.
• Even if you set "48kHz/96kHz PCM" to "96kHz/24bit", the sampling frequency is converted
to 48 kHz/16 bit when a "SURROUND" mode (page 83) is selected.
• The analog audio signals from AUDIO OUT L/R jacks are not affected by "48kHz/96kHz
PCM" setting and keep their original sampling frequency level.
64
Audio Setup
Normally select this position.
Makes the low sounds clear even if you turn the volume down.
The audio signals of DVD VIDEOs are always converted to
48 kHz/16 bit.
All types of signals including 96 kHz/24 bit are output in their
original format. However, if the signal is encrypted for copyright
protection purposes, the signal is only output as 48 kHz/16 bit.