Table of Contents
Advertisement
Programme default settings
en
Soaking
Switch on the appliance.
1.
Select the Cottons 30 °C
2.
programme.
Pour soaking agent/detergent into
3.
compartment II in accordance with
the manufacturer's instructions.
Press the A button. The
4.
programme starts.
After approx. 10 minutes, press the
5.
A button to pause the programme.
Leave the laundry to soak for as long
6.
as required, then either press the A
button again to continue the
programme or change the
programme.
Notes
Load laundry of the same colour.
■
No additional detergent is required;
■
the soaking solution is used for
washing.
0
Programme default
settings
m m e
P r o g r a
The default programme settings are
displayed in the display panel after
selecting the programme.
You can change the default settings.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
~ Page 14.
18
t
d e f a u l
Temperature
(Temp. s)
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin
0
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting $: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
~ Page 23
i n g s
s e t t
The maximum speed that can be set
depends on the model and programme
that has been selected.
Finished in
ñ
Before starting the programme, you
can preselect the programme end
("Ready in" time) in hourly increments (h
= hour) up to a maximum of 24 hours.
To do this:
Select a programme.
1.
The programme duration is
displayed for the selected
programme, e.g. 2:30
(hours:minutes).
Advertisement
Chapters
Table of Contents
