Equipment Interface Instruction - Pylontech KH-ES4850 Owner's Manual

2.3 Equipment interface instruction

Start
Turn on: press ON/OFF hole more than 1s to start the battery
moduleTurn off: press ON/OFF hole more than 1s to turn off
the battery.
RUN
Green LED lighting to show the battery running status
Alarm
Red LED flashing to show the battery has alarm; lighting to show the battery is
under protection.
SOC
6 green LEDs to show the battery's current capacity.
ADD Switch
Dip1: RS485 baud rate 1: 9600; 0: 115200. The settings will be active only after
restart the battery.
Dip2~4, address of multiple battery group connection. Change the setting of
master battery ONLY.
11