Table of Contents
Advertisement
1 NOMENCLATURE
1 NOMENCLATURE
④
③
②
①
㉕
㉔
㉓
㉓
㉖
PL Mount lens Only
Information Display (Common to CN7x17, CN10x25)
①
DISPLAY
For the operation of the digital drive unit, refer to "Information Display Manual" in the
⑤
⑥
⑧
⑦
⑨
⑫
⑬
⑭
⑮
⑯
⑰
⑱
⑲
⑳
㉒
㉑
②
③
CN7x17
① Iris Gain Adjusting Trimmer
② Instant Auto-Iris Switch
③ Iris Operation Mode Change-over Switch
④ Zoom Rocker Seesaw
⑤ RET Switch (Video Return Switch)
⑩
⑥MEMO Switch (Memory Switch)
⑦ AUX Switch
⑪
⑧ Flange Back Lock Screw
⑨ Flange Back Adjusting Ring
⑩ Macro Button
⑪ Macro Ring
⑫ Iris Ring
⑬ Zoom Ring
⑭ Focus Ring B
⑮ Zoom Lever
⑯ Focus Ring A
⑰ Focus Operation Change-over Knob
⑱ Zoom Operation Change-over Knob
⑲ Three Screw Holes for Storing the Drive Unit
Fixing Screws
⑳ Max. Zoom Speed Volume
㉑ 12-pin Cable
㉒ VTR Switch
㉓ Remote Connectors (20-pin)
NOTE) Only Connector ★ can be used as the iris
remote or virtual output port.
Use these connectors to connect the control accessory
(equipped with a 20 pin connector) for zooming or focusing.
Connector ★ has also a function to operate the iris through
a focus control accessory and a dedicated cable and a
function to interface with various virtual systems. It can
output each positioning signal of zoom, focus, and iris.
㉔ Hood Lock Knob
㉕ Lens Holder
㉖ Lens Cable Connector (12-pins)
NOTE) PL mount lens only
① Display Switch
Used to turn the display ON/OFF.
② Display
It turns off if left for 2 minutes without operation.
③ Control key
Used to move the cursor up/down/left/right. Press the
center to confirm.
E2
supplied
CD-ROM.
Advertisement
Table of Contents
