Setting Up The Monitor - HP L1815 User Manual

hp L1815 LCD Monitor

Setting Up the Monitor

Setting Up the Monitor
Where to place the monitor
Place the monitor on a flat, sturdy surface. Ensure that the operating
site is free from excessive heat and moisture. For best performance,
make sure nothing is resting on the monitor.
WARNING:
!
Connecting two computers to the monitor
The LCD monitor has two video signal connectors on the rear panel:
one D-SUB analog (VGA) and one digital (DVI-I). This allows you to
connect the monitor to up to two computers at the same time.
Connecting the cables to the monitor
Look at the following diagram and follow the steps listed below to
connect the cables to the LCD monitor.
CAUTION:
8
Before you connect any cables or install the HP
monitor, refer to the safety instructions at the
beginning of this manual. Refer also to the
documentation that came with the computer to
ensure this equipment is correctly installed.
This monitor is equipped with an auto-sensing power
supply for voltage ranges 100—240 V AC, 50/60
Hz. Use the monitor with the supplied DC adapter
only.
DVI-I
Note: this image shows connection to
the VGA connector only
D-SUB (VGA)