Bevel Adjustment - Bosch GKT13-225L Operating/Safety Instructions Manual

2610051844.qxp_GKT13-225 9/17/18 10:16 AM Page 17
▶ Depth adjustment
one tooth length of the blade should
extend below the material to be cut.
A. Disconnect plug from power source.
B. Turn cutting-depth indicator 8 to the
bottom position a for sawing without
track, or to the upper position b for
sawing with track (Fig. 21).
C. Squeeze the depth-stop slider 27 and
move it to the desired depth (material
thickness plus one tooth length) on
cutting-depth scale 6 (Fig. 22).
Note: Correct depth setting can also
reduce splintering.
Fig. 21

▶ Bevel Adjustment

blade engagement in the work and
decreased stability of the foot, blade
binding may occur. Keep the saw
steady and the foot firmly on the
workpiece.
- Loosen the knobs 11 and 17. Tilt the
saw sideward (Fig 1).
- Adjust the saw to the desired bevel
angle on the scale 9. Tighten the
knobs 11 and 17 again.
17
Operating Instructions
To reduce the risk of
injury, no more than
Because of the in -
creased amount of
Fig. 20
No more than one tooth length
should penetrate workpiece
The bevel angle of the saw can be
adjusted to –1° or +47°.
For the –1° bevel angle, additionally
push button 16 while tilting, or for the
+47° bevel angle, push button 12 while
tilting (Fig. 1).
Note: For bevel cuts, the cutting depth is
smaller than the setting indicated on the
cutting-depth scale 6.
Note: Before making bevel cuts, retract
the clear viewing window 13 all the way
up.
Fig. 22
6
8
27