Worksaver ATVK-400 Owner's/Operator's Manual
  1. Manuals
  2. Brands
  3. Worksaver Manuals
  4. Spreader
  5. ATVK-400
  6. Owner's/operator's manual

Worksaver ATVK-400 Owner's/Operator's Manual

Atv broadcast seeder -spreader
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
OWNER'S /
OPERATOR'S
MANUAL
MODEL NO.
ATVK-400
CAUTION
For Safe Operation
Read Rules And
Instructions Carefully
SINO LEEINGLES, PIDA AYUDA
A AIGUIEN QUE SI LO LEA
PARA QUE LE TRADUZCA LAS
MEDIDAS DE SEGURIDAD.
STATEMENT
OF POLICY
It is the policy of Worksaver,
Inc. to improve its products
where it is possible and practical
to
do
so. Worksaver,
reserves the right to make
changes or improvements in
design and construction at any
time, without incurring the obliga-
tion to make these changes on
previously manufactured units.
ATTENTION! SAFETY RULES
1. Read instruction manual and make sure all operators are knowledgeable on
correct operation of equipment and familiar with the Safety Rules of Operation.
2. Never allow riders on equipment.
3. When operating on rough or uneven terrain, use extreme caution and a safe
operating speed.
4. When spreading seed or fertilizer, always use safety goggles.
5. Never operate equipment when anyone is within 50 feet of seeder/spreader.
Before operating equipment – If you have any questions regarding the proper assembly or
operation, contact your dealer or representative.
Broadcast Seeder - Spreader
Inc.
Safety Instructions
Tractor Preparation
Operating Instructions
ATV
Assembly & Mounting
Maintenance
Repair Parts

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATVK-400 and is the answer not in the manual?

Questions and answers

Related Manuals for Worksaver ATVK-400

Summary of Contents for Worksaver ATVK-400

  • Page 1 A AIGUIEN QUE SI LO LEA PARA QUE LE TRADUZCA LAS MEDIDAS DE SEGURIDAD. STATEMENT OF POLICY Broadcast Seeder - Spreader It is the policy of Worksaver, Inc. to improve its products where it is possible and practical so. Worksaver, Inc. Safety Instructions Assembly &...
  • Page 2 To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded opera- tor who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. BEFORE YOU START!! Read the safety messages on the implement and shown in your manual.

  • Page 3: Safety Information

    SAFETY INFORMATION (continued) All equipment is potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes potential hazards and follows reasonable safety practices. When the use of hand tools is required to perform any part of assembly, installation, adjustment, maintaining, repairing, removal, or moving the implement, be sure the tools used are designed and recommended by the tool manufacturer for that specific task.

  • Page 4: Safety Signs

    SAFETY INFORMATION (continued) Never operate broadcast spreader if anyone is within 50 ft. of ATV and spreader. Never use your hand or fingers to clear a jam of material in the feed gate. Use a clean stick or rod. When spreading any material, always use safety goggles or safety glasses with side shields. When spreading, always be aware of the wind direction and that it may carry the material further than normal spread width.

  • Page 5: Vehicle Preparation

    INSTRUCTIONS VEHICLE PREPARATION With the seed gate (middle plate) in the closed position, place the scale plate lever in the closed position. The 12 volt electric seeder can be mounted on most all Retighten the adjustment bolt so that the adjustment but- terrain vehicles (ATV).

  • Page 6: Pre-Operation

    INSTRUCTIONS (continued) PRE-OPERATION 3. FOR BEST RESULTS use pelletized fertilizer, as it has little tendency to lump and cause little or no dust. • Know your controls and how to stop ATV, engine, or pickup quickly in an emergency. READ THIS MANUAL 4.

  • Page 7: Maintenance

    INSTRUCTIONS (continued) SPREADING INSTRUCTIONS If twice over spread is used as recommended, and (cont.) area is not too large, it is advisable to put approxi- mately one-half of material in hopper. This will give an approximate check of rate usage and will allow for adjustments after first time over.
  • Page 8 INSTRUCTIONS (continued) NOTE: Since there is no agitator in the seed hopper, these materials will bridge at narrow seed gate settings and cause erratic seeding rates. If bridging occurs at wider seed gate settings, cleaning the seed or blending with a small dense seed such as clover may help.
  • Page 9 ATVK-400 MOUNTING KIT PARTS LIST...
  • Page 10 ATV BROADCAST SEEDER-SPREADER PARTS DRAWING...
  • Page 11 ATV BROADCAST SEEDER-SPREADER PARTS LIST...
  • Page 12 (6) months from date of purchase. GIVE THE FOLLOWING Upon written approval, Worksaver will repair or exchange without charge any part, which upon examination by Worksaver or its authorized agent, shall disclose to be INFORMATION: defective.

Table of Contents