HP ProBook 4425s Getting Started page 11

Backing up
Recovery after a system failure is as complete as your most current backup. You should
create system repair discs (select models only) and your initial backup immediately after
software setup. As you add new software and data files, you should continue to back up your
system on a regular basis to maintain a reasonably current backup.
Use Backup and Restore to create a backup. Click Start, click All Programs, click
Maintenance, and then click Backup and Restore. Follow the on-screen instructions to set
up your backup, create a system image (select models only), or create a system repair disc
(select models only).
Recovering
In case of system failure, use the f11 recovery tool to recover your original hard drive image.
The image includes the Windows operating system and software programs installed at
the factory.
Ä
CAUTION
files you have created and any software installed on the computer are permanently removed.
The f11 recovery tool reinstalls the operating system and HP programs and drivers that were
installed at the factory. Software, drivers, and updates not installed at the factory must be
reinstalled. Personal files must be restored from a backup.
1. If possible, back up all personal files.
2. If possible, check for the presence of the HP Recovery partition. To find the partition,
click Start, right-click Computer, click Manage, and then click Disk Management.
If the HP Recovery partition is not listed, you must recover your operating system
and programs using the Windows 7 Operating System DVD and the Driver
Recovery disc. To purchase these discs, contact technical support. Refer to the
"Contacting technical support" section in the back of this guide.
3. If the HP Recovery partition is listed, restart the computer, and then press esc while the
"Press the ESC key for Startup Menu" message is displayed at the bottom of the screen.
4. Press f11 while the "Press <F11> for recovery" message is displayed on the screen.
5. Follow the on-screen instructions.
Windows provides additional recovery tools through the operating system. For
additional information, go to Help and Support.
If you are unable to boot (start up) your computer, you must purchase a Windows 7
Operating System DVD to reboot the computer and repair the operating system. For
additional information, contact technical support. Refer to the "Contacting technical
support" section in the back of this guide.
Getting Started
:
Using f11 completely erases hard drive contents and reformats the hard drive. All
What's Next?
7