Table of Contents
Advertisement
Regularly examine the drum to check for
limescale.
Regular detergents already contain water
softening agents, but we recommend to
run a cycle with an empty drum and a
descaling product occasionally.
Always follow the
instructions that you find on
the packaging of the
product.
12.3 Maintenance wash
The repeated and prolonged use of low
temperature programmes can cause
detergent deposits, fluff residues,
bacterial growth inside the drum and the
tub. This could generate bad odours and
mildew. To eliminate these deposits and
clean the inner part of the appliance, run
a maintenance wash regularly (at least
once a month).
Refer to Cleaning the drum
chapter.
12.4 Door seal
Regularly examine the seal and remove
all objects from the inner part.
12.5 Cleaning the drum
Regularly examine the drum to prevent
rust forming.
Clean the drum with special products for
stainless steel.
Always follow the
instructions that you find on
the packaging of the
product.
For a thorough clean:
• Remove all laundry from the
drum.
• Select the Cotton
with the highest temperature
Add a small quantity of powder
detergent into the empty drum, in
order to rinse out any left
residues.
Occasionally, at the
end of a cycle the
display may show the
icon
This is a
recommendation to
perform the "drum
cleaning".
12.6 Cleaning the detergent
dispenser
To prevent possible deposits of dried
detergent or clotted fabric softener
and/or formation of mould in the
detergent dispenser drawer, once in a
while carry out the following cleaning
procedure:
1. Open the drawer. Press the catch
downwards as indicated in the
picture and pull it out.
2. Remove the top part of the additive
compartment to aid cleaning and
flush it out under running warm
water, to remove any traces of
accumulated detergent. After
cleaning, put the top part back into
position.
ENGLISH
25
programme
1
2
Advertisement
Table of Contents
