Janome 5060DC Instruction Book page 11

r
t
y
u
i
r Auto-lock button
Press the auto-lock button r to sew a locking stitch
immediately. The machine will automatically stops.
Any other stitches
Press the auto-lock button r to sew a locking
stitch at the end of current pattern. The machine will
automatically stop.
t Needle up/down button
Press the needle up/down button t to bring the
needle up or down.
y Thread cutter button
Press the thread cutter button y to trim the threads
after sewing.
The thread cutter mark will blink u while the machine
cuts the threads.
You can continue sewing without pulling the bobbin
thread up after trimming the threads.
To trim the threads automatically after sewing, select
the desired stitch pattern, then press and hold the
thread cutter button until the thread cutter mark
appears i.
The machine will trim the threads automatically after
the locking stitch then stop when the reverse or auto-
lock button is pressed, or a pattern has the auto-lock
stitch programmed.
NOTE:
Use the thread cutter on the face cover if the thread is
#30 or thicker.
7