Golden MAXICOMFORT EZ Sleeper PR-761 Owner's Manual page 14

A D
uto rive with
Hand control disable, disables all functions on the hand control.
1. To disable, press and hold the program button (SP) for 4 seconds until the
backlight starts flashing. Then press button (S7).
2. To enable, press and hold the program button (SP) for 4 seconds until the
backlight starts flashing. Then press button (S7).
Should you ever want to limit the button function of your hand control, you can use
the function lock feature to disable all button function except for buttons (S7 and
S9).
1. To lock function, press and hold the program button (SP) for 4 seconds until
the backlight starts flashing.
2. Press button (S1), press button (S2), press button (S3), press button (S6).
3. To unlock function, press and hold the program button (SP) for 4 seconds until
the backlight starts flashing.
4. Press button (S1), press button (S2), press button (S3), press button (S6).
PR761 Hand Control Inside Arm Routing
To move the hand control from one side to the other, follow the instructions
below.
1. Lift the bottom of outside back from the Velcro on the arm cross rail.
2. Remove the hand control
wire from the J-Clip.
3. Unlock the extension
wire, and separate.
Note: This step
disables all lift chair
functions.
4. Route the hand control
wire through the
opposite J-Clip.
5. Reconnect the
extension wire, and lock
to secure.
t -C
wilight ontrol
Hand Control Disable
Function Lock
J-Clip
P-Clip
14
o
perAtion
Lock
Extension
-
ContinueD
J-Clip
Hand Control