Table of Contents
Advertisement
A
D
uto
rive with
1. To move the head rest up and out. Press button (S14) and hold it until the
head rest reaches a position suitable for you, then release the button.
2. To move the head rest down and in. Press button (S13) and hold it until the
head rest reaches a position suitable for you, then release the button.
1. To move the lumbar out. Press button (S16) and hold it until the lumbar
reaches a position suitable for you, then release the button.
2. To move the lumber in. Press button (S15) and hold it until the lumbar
reaches a position suitable for you, then release the button.
Programming the Memory Buttons S5, S6, S8 and S10
Press one of the preprogrammed buttons (S5, S6, S8, S10) and hold until the chair
stops. Press buttons (S1 thru S4, S11 and S12) to micro adjust those positions to suit
your needs. Use the following procedure to reprogram (S5, S6, S8, S10) buttons
after you have the chair in your desired position.
Press and hold program button (SP). The back light goes off while pressed.
1. In about 3 seconds the backlight will start flashing (one flash)
2. Within 5 seconds, press one of the memory buttons (S5, S6, S8, S10) to save
the position to the button pressed. The back light will return to non-flashing
position indicating that the new position is stored.
If a programmable memory button is not pressed within 5 seconds, or a nonprogram-
mable button is pressed, then the programming sequence is aborted and you will
need to repeat steps 1 to 3 above. You may reprogram the memory buttons as often
as you like.
Resets all the programmed buttons (S5, S6, S8 and S10) back to the factory settings.
1. Press and hold program button (SP). The backlight goes off while button is
pressed.
2. In about 4 seconds the backlight will start flashing.
3. Within 5 seconds, press button (S1). The backlight will change to non-flashing.
4. Within another 5 seconds, press button (S4). Factory reset is done.
If button (S1) is not pressed within 5 seconds, or a different button is pressed, then
the programming sequence is aborted and you'll need to repeat steps 1 to 4 above.
t
-C
wilight
ontrol
Headrest Adjustments
Lumbar Adjustments
Factory Reset
13
o
-
perAtion
ContinueD
Advertisement
Table of Contents
