Related Manuals for EVBIKE SET-36V-26F
Summary of Contents for EVBIKE SET-36V-26F
- Page 1 All manuals and user guides at all-guides.com INSTALLATION MANUAL Wheel Drive Electric Bicycle Kit EVBIKE-SET-36V-26F EVBIKE-SET-36V-26R EVBIKE-SET-36V-28F...
- Page 2 All manuals and user guides at all-guides.com Thank you for purchasing EVBIKE product and we hope that you will become a happy user. Carefully read the entire manual prior to installation and first use! If you find any fact in the manual that would prevent you from using our product, please contact your reseller for further discussion and keep the original packaging.
-
Page 3: Table Of Contents
Maximum rim load: 70 kg** Rim material: Alluminium alloy 6061, (double wall) * Total bicycle load up to 120 kg must not be exceeded (includes the weight of the rider, bike and EVBIKE set). www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344... - Page 4 Pedal assistant LCD display + fi xing Accelerator Cable harness For succesful assembly of EVBIKE, you will also need following: • ribbons for cables fastening • screws, nuts, washers • special bott om bracket tools (see pictures a, b, c) •...
-
Page 5: Instaling Evbike Hub Motor
1. INSTALLING EVIBIKE HUB MOTOR 1) Remove the original wheel and swap tire to the EVBIKE HUB motor rim. Remove the original wheel and put tire with tube to the EVBIKE rim. Remember also protective wheel rim strip. Newly assembled wheel with HUB motor should be checked and trued after 100-200 km. - Page 6 • The cable come out on left side of rear fork when the bike is in normal position. • After installation the hub motor you will need to adjust the sorting of gears. Its needed to avoid a collision with the hub motor. www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344...
-
Page 7: Pedal Assistant
7) Before final tightening of all screws is necessary to check the correct functioning of pedaling detection. If you mount kit on a scooter, or operate it only in accelerator mode, you can skip pedal assistant assembly. www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344... -
Page 8: Controller And Cabling
Damages due the incorrect cable or pins connecting will void your warranty. When connecting the motor connector and controller, make sure that the arrows on the connectors facing each other (Fig. 13). Brake Accelerator LCD display Brake www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344... -
Page 9: Lcd Panel Installation And Usage
Maximum speed and total Push Function (6 km/h) Power of the Engine (W) Power Assist Ratio (PAS), Trip Distance – Battery Surrounding (°C) Gear or Cruise Control (C = CRUISE) Voltage www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344... - Page 10 14. Surrounding temperature in °C or °F * Recovery function can be set in several grades. Incorrect setting can damage your battery or other electrical equipment components. For proper configuration, please contact the service partner EVBIKE. Description of the control buttons:...
- Page 11 . Recovery activation is accessible only by an authorized partner of EVBIKE and before its setting you must verify that the used battery and its protective system supports this kind of charge. 4. Indication accelerator function – this function symbol indicates the rotating parts around the perimeter of two digital digits 88 on-site display of the surrounding temperature.
- Page 12 All contacts must be clean and dry. If this or battery) error occurs regularly, it will be necessary to stop using the bike and get to a repair service. www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344...
- Page 13 You can set these wheel diameters: 6, 8, 10, 12, 14, 16, 18, 20, 22, 24, 26, 700 C and 28 inches. For the speed measurement the unit EVBIKE uses signals from the hall probes of the engine.
-
Page 14: Brakes, Accelerator, Handle
Wash with clean water using a damp cloth. Do not concentrate on meter while riding. Safety fi rst! CAUTION NEVER MANIPULATE MOVING PARTS IF BATTERY IS CONNECTED. RISK OF SERIOUSLY INJURY! BEFORE HANDLING TURN OFF LCD DISPLAY, DISCONNECT BATTERY AND REMOVE IT OUT OF THE HOLDER. www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344... -
Page 15: Maintenance
Decree-Law No 176/2008 Coll., establishing technical requirements for machinery (MACHINERY DIRECTIVE 2006/42/EC, 2009/127/EC). This statement is issued on the basis of documents presented by the producer. www.EVBIKE.cz Importer: GWL Power Ltd., EU-VAT ID: CZ682998344...
Need help?
Do you have a question about the SET-36V-26F and is the answer not in the manual?
Questions and answers