Installation Of Indoor Unit - Boreal Brisa BRS12HPL1IA Owner's Manual

Installation of indoor unit

Step one: choosing installation location
Step two: install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws and then check if
the frame is firmly installed by pulling the frame. If the plastic expansion particle
is loose, please drill another fixing hole nearby.
Step three: open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
Wall
Space
to the
wall
above
150mm
(5.9in)
Left
Φ55mm
(Φ2 1/4)
Rear piping hole
9K 115V
Wall
Space
to the
wall
above
150mm
(5.9in)
Left
Φ55mm(Φ2 1/4)
Φ70mm(Φ2 3/4)
Rear piping hole
2. Open a piping hole with the diameter of Φ55 or Φ70 on the selected outlet pipe
position.In order to drain smoothly, slant the piping hole on the wall slightly
downward to the outdoor side with the gradient of 5-10°.
Level meter
Rear piping hole
Level meter
Rear piping hole
18K 230V
Wall
Wall
Space
Space
to the
to the
wall
wall
above
above
150mm
150mm
(5.9in)
(5.9in)
Left
Right
Φ55mm
Φ55mm
(Φ2 1/4)
(Φ2 1/4)
Rear piping hole
Wall
Wall
Space
Space
to the
to the
wall
wall
above above
150mm 150mm
(5.9in)
(5.9in)
Right Left
Φ70mm
Φ55mm(Φ2 1/4)
(Φ2 3/4)
Φ70mm(Φ2 3/4)
Rear piping hole
31
rm it with the client.
Mark in the middle of it Level meter
12K 115V
Level meter
Mark in the middle of it
24K 230V
Wall
Space
to the
wall
above
150mm
(5.9in)
Right
Φ55mm
(Φ2 1/4)
Rear piping hole
Wall
Space
to the
wall
above
150mm
(5.9in)
Right
Φ70mm
(Φ2 3/4 )
Rear piping hole