Table of Contents
Advertisement
Thawing out the Accessories
In case of optional drain hose
• Wrapping the optional drain hose with a towel
soaked in hot water at 60 ℃.
In case of water container
• Immerse the water container in hot water at 60
℃.
Thawing out the Appliance
Running thawing mode
1
Turn on the appliance and press the Less Time
button for 3 seconds.
NOTE
• Only Less Time button on the control panel is
pressed to activate the thawing mode.
• Only Power and Start/Pause buttons work
when the thawing mode is activated.
• It does not allow you to change the thawing time
manually.
• To deactivate the thawing mode, turn off the
appliance.
2
Press the Start/Pause button to start the
thawing mode.
• Actual thawing time varies depending on the
installation environment such as installation
location and ambient temperatures of the
appliance.
3
Dry the clothes as usual.
Thawing out the appliance manually
1
Open the dryer's door and pull out both inner
and outer filter.
2
Pour 1 litre of hot water at 60 ℃ into the lint
filter compartment and then reinsert the both
lint filters.
CAUTION
• Pouring more that 1.5 litres of water into the
compartment will cause water to leak back out.
• Pouring hot water over 60 ℃ will cause
malfunctions to the appliance or burn.
3
Turn on the appliance and operate the Cotton
programme about 30 seconds. Then wait
about 30 minutes.
4
Operate the Cotton programme again. Check
if the
message will appear or
OE
within 10 minutes after operating the
appliance.
• When the
message or
OE
to step 2 and repeat procedure.
• Nothing appears on the display when the
thawing is done.
5
Dry the clothes as usual.
MAINTENANCE
will light up
E
E
icon appears go
37
Advertisement
Table of Contents
