Installation Instructions - Smeg KD120XE Instruction Booklet

INSTALLATION INSTRUCTIONS:

EN
The hood is supplied with all the accessories necessary for
its installation. The minimum distance between the lower
surface of the hood and the hob must be at least 750 mm
for gas hobs and 650mm for electric hobs (Fig. 1 ). If
the motor inlet is equipped with a non-return valve for
fumes, make sure it can open and close freely.
For easy installation it is recommended to follow the procedures
described below:
1) The hood must be centred with respect to the hob surface.
2) There are different installation procedures depending on
the hood model. Choose one of the following fixing systems
(Fig.2):
a) 2 levelling hooks that fasten on with the supplied
expansion plugs
b) Rear levelling bracket that fastens on with the supplied
expansion plugs
c) Levelling anchors on motor box that fasten on with the
supplied expansion plugs
d) For island models refer to the special installation
attachment.
N.B.: Fixing systems a) and b) fit on to the back of the hood
in the holes L1 (Fig. 4 ).
3) Remove the grease filters and position the hood on the wall
and mark the reference position for the holes to anchor the
relative fixing system.
4) Drill the 2 holes previously marked after removing the hood
from the wall
5) Anchor the fixing system to the wall by tightening the
expansion plug
6) Mark holes L2 on the wall to secure the plugs safely in the
holes. (plugs supplied)
7) Hang the hood on the fixing system (fig. 2) and level it
using the adjustment screws ( fig.2 ).
8) Securely fix the hood by fully tightening the two expansion
screws of the holes L2
AIR CONNECTION SYSTEMS:
EXTRACTION version: Connect the fume expulsion duct
(inside diameter 150 mm.) to the exhaust of the motor inlet.
If the expulsion duct is D.120mm, use the special reduction
flange (F) supplied, where applicable. The expulsion duct
must not have a diameter of less than 120 mm.
Note that if the hood is supplied with an active carbon
filter, this must be removed (see page 8)
Deviation for Germany:
When the hood and other appliances powered by energy other
than electricity are simultaneously ON, the negative pressure
in the room must not exceed 4 Pa (4 x 10-5 bar).
3