Advertisement
6)
Mains voltage indication. When noted "115", the power supply is
configured for 100-120Vac, 50-60Hz voltage range. If noted "230", the power
supply is configured for 220-230Vac/50-60Hz mains voltage range
7)
Mains IEC connector. Place mains power cord at this connector. The
power supply is optimized such that lowest leakage current will be present
when AC phase is applied to the (L / phase pin) pin of the connector
8)
Serial number. Always refer to this number in any communication with your
dealer or Farad power supplies directly.
9)
Earth connector. External earthing of the Super10.
9a) Float switch: The earth connector can be connected to the output GND
by a 10R resistor parallel to a choke (ON), or disconnected to make a
floating power supply (FLOAT). For safety line earth is always connected to
the Super10 housing.
9b) Earth connector: You can connect an extern earth or earth box here,
the earth connector takes a bare wire, small spade and banana.
IMPORTANT NOTE: Always switch off and mute devices when connecting or
disconnecting the Farad power supply.
When you have any questions about our power supplies, please contact us at
info@Faradpowersupplies.com with serial number stated at the back (see figure 1,
position 8) of the power supply. We will reply to you as soon as possible.
Trouble Shooting
Most problems in audio systems are the result of poor or wrong connections or
cabling. Always check if the mains power connector and the DC power connector are
plugged in tight and correctly. Also check if the cables are functioning properly, and
there are no loose wires. When not sure, try a different cable, and see if this solves
the problem.
Below are some common failures. If you encounter another problem, or the below
solutions do not solve the problems, please contact your dealer, or contact us directly
at info@Faradpowersupplies.com.
Front LED does not light up (in any color), or strange vague signaling
Microprocessor needs reset. Press reset switch at position 3 for two seconds.
If this does not help, there is no AC mains power on the power supply. Check if mains
cables and power cables are plugged in tight and correctly, and if AC voltage is
present at the wall outlet. If this is the case and led still does not light up, please go to
your Farad dealer or contact Farad power supplies directly.
10
Advertisement
