Table of Contents
Advertisement
Operation Manual / TPL67-C.. - TPL71-C..
8 Disassembly and assembly / 8.7 Installing cartridge group
© Copyright 2018 . All rights reserved.
Fit O-ring (42012).
u
Attach lifting gear to the shackle of the lifting device (90190) and turn
u
the compressor casing (72000).
Screw three press-off nuts (61090) onto bearing casing studs, equally
u
distributed around circumference, and screw up to end of thread by
hand.
Push the compressor casing (72000) flush onto the cartridge group
u
and attach with nuts (61037).
Secure the three press-off nuts (61090) against the compressor cas-
u
ing (72000) with the appropriate tightening torque (see chapter Table
of tightening torques).
Remove lifting device (90190).
u
HZTL2488_EN
Revision E
August 2018
Advertisement
Table of Contents
