Table of Contents
Advertisement
10
Operating
Operation
Basic operations
1. Turn the unit on by pressing any key on the
unit.
2. Select a source by pressing SRC.
3. Rotate the volume knob to adjust the volume
on the unit.
Or press VOLUME W/S on the remote control.
,
Note
If a source is not connected to the unit, the
source is not recognized.
3
Turning off the sound
temporarily
1. Press MUTE to mute your unit.
Or press MUTE on the remote control.
2. To cancel it, press MUTE again.
Using EQ (Equalizer)
EQ is to increase or decrease the signal strength of
audio frequencies. The function helps you to enjoy
sound more plentifully.
Press EQ/ • XDSS+ on the unit repeatedly. The
indicator lights up in the following order.
POP / CLASSIC / ROCK / JAZZ / VOCAL /
SALSA / SAMBA / REGGAE / RUSSY / USER 1
/ USER 2 / Off (not displayed)
,
Note
When XDSS+ is set to "Off ", you can adjust
the EQ settings.
You can adjust sound level to your
preference. Once you select a USER 1/2
mode and press ` on the unit, then adjust
the sound level (BASS (bass), MID (middle),
TRB (treble), BAL (left/right speaker), FAD
(front/rear speaker), S--W (Sub-woofer:
optional)), it will be automatically stored for
the currently selected USER 1/2 mode. Refer
to the "For [SOUND] setting" for USER 1/2
mode on the page 11.
Using XDSS+ (Extreme
Dynamic Sound System)
It improves the treble and bass sound.
1. Press and hold EQ/ • XDSS+ on the unit.
2. To cancel it, press and hold it again.
Checking the clock
1. Press DISP to check the clock.
2. Press it again to remove it.
Turning off the display light
1. Press and hold DISP.
2. Press and hold it again to turn it on.
,
Note
Under the light-off condition, press any
keys, the light is turned on and then off
automatically if you don't press it within a few
seconds.
Resetting the unit
You can reset the unit when it does not operate
properly.
1. Detach the control panel.
Refer to page 7 for detaching the control panel.
2. Press the RESET hole with a sharp object.
Advertisement
Table of Contents
