Table of Contents
Advertisement
Electrical connection
:
Warning – Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do
not kink or pinch the connecting cable during
installation.
The required connection data can be found on the
rating plate inside the appliance; to do this, remove the
metal mesh grease filter.
Length of the cable: approx. 1.30 m
This appliance complies with the EC interference
suppression regulations.
:
Warning – Risk of electric shock!
It must always be possible to disconnect the appliance
from the electricity supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed.
The mains plug of the mains power cable must be
easily accessible after installation of the appliance. If
this is not possible, an all-pole isolating switch must be
integrated into the permanent electrical installation
according to the conditions of overvoltage category III
and according to the installation regulations.
The permanent electrical installation must only be wired
by a professional electrician. We recommend installing
a residual-current circuit breaker (RCCB) in the
appliance's power supply circuit.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
5Installation
P reparing the installation
I n s t a l l a t i o n
Caution!
Ensure that there are no electrical wires, gas pipes or
water pipes in the area where holes are to be drilled.
Mark a vertical centre line on the wall from the
1.
ceiling to the lower edge of the extractor hood.
Use the enclosed template to mark the positions for
2.
the screws and the outline of the attachment area.
Drill five 8 mm diameter holes to a depth of 80 mm
3.
for fastening the appliance and press in the wall
plugs flush with the wall.
Installation
en
15
Advertisement
Table of Contents
