tV menu
Source labels
You can assign a label to each input source as you
prefer in the label list�
1�
Go to
installation > Source labels
2�
Assign a input source and press > to select a
label from label list.
3�
Press
b on the remote control and check the
result.
assign a channel decoder (For atV)
Decoders that decode channels can be connected to
SCART� You have to assign the TV channel as a channel
to be decoded� Then assign the connection where the
decoder is connected�
1�
Press MENU on the remote control and select
installation > Decoder.
TV Menu
Installation
Language
Country
Channel installation
Source labels
Decoder
Current software info
AV reset
Factory reset
2�
Press
≥ to enter the list.
3�
Press
< or > to select the channel to decode.
4�
Press
oK to select or unselect the channel.
5�
Press
≤ to return to the previous menu.
6�
Press
menu to exit.
Check your current software version
Press menu on the remote control and select
installation > Current software info.
update software (digital broadcasts)
If using (DVB-T) digital broadcasts, your TV automatically
receives software updates� If you receive a message
on-screen prompting you to update your software:
Decoder
1 ...
2 ...
3 ...
•
Select
accept (recommended) to update the
software immediately.
reject to exit the update (not
•
Select
recommended).
•
remind me later to be reminded to update
Select
the software later.
note
•
To scan all carriers for upgrade availability, perform the manual
upgrade�
•
The software upgrade may take about 30 minutes, but may
take longer (up to 1 hour) depending on the signal status�
Caution
Do not disconnect the AC cord when the software
upgrade is in progress, as this may cause the upgrade
to fail. If problem arises ask a qualified service
personnel before the software upgrade period expires.
aV reset
To reset the Audio and Video to default settings�
1�
Press MENU on the remote control and select
installation > aV reset
2�
Press
≥ to select "Start now" and press oK.
3�
Press
menu to exit.
Factory reset
When you activate the Factory reset , the TV needs to
be reset from First time installation�
1�
Press MENU on the remote control and select
installation > Factory reset
2�
Press
≥ to select "Start now" and press oK.
3�
Press
menu to exit.
25