Table of Contents
Advertisement
F791
ImageFlat Color Monitor
1.
Insert the 15-pin signal cable connector to the VGA connection on your
computer and screw it down.
2.
Plug the display unit's power cable first to the back of the display unit.
3.
Then plug the power cable to a 100V - 240V earthed electrical outlet or to the
system unit, if it has an outlet for the display power cable.
4.
Turn on the display unit using the power switch and check that the power
LED is on. If not, repeat steps 2, 3 and 4 or refer to the Troubleshooting section
of this guide.
5.
Turn on the power to the computer. The picture will appear within about 15
seconds. Adjust the picture to obtain optimum picture quality. See the section
Adjusting the picture in this guide for more information.
Power LED
Power Switch
6/19
Advertisement
Table of Contents
