Final Check List/Initial Start Up - Scotsman iceValet HD30 Product Manual

HD22 and HD30

Final Check List/Initial Start Up

1. Check that electrical power has been supplied.
2. Check that a drain, separate from the ice
machine, insulated and made of rigid tubing, has
been connected to the dispenser.
3. Check that the ice machine has been properly
installed per the ice machines installation
directions.
4. Check that the ice machine/dispenser assembly
is level front to back and left to right.
5. Check that optional kits, if any, have been
correctly installed.
6. Check that the coin box access key, if used, is
available.
To Start:
1. Connect electrical power. The dispensing
system will cycle on for a few seconds.
2. Go thru ice machine start up procedures. Let ice
machine make two harvests.
3. Push the ice chute in.
4. Dispense wheel turns.
5. Ice will be dispensed from ice chute.
6. Fill out the warranty registration form and place
it in the mail.
7. Give the operator any keys and the instructions
on the operation and maintenance of the product.
Check that the operator knows who to call for
service, and has the product/service manuals for
the machines.
Electrical Sequence
Pushing the ice chute closes a contact to the gear
motor.
The gearmotor will have power and the dispenser
will continue to operate as long as the ice chute is
pushed in. This model also has a agitation cycle of
3 seconds every 6 hours. Since the ice chute is not
pushed in during agitation no ice is dispensed.
September 2003
Page 10