Advertisement
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
Plug the power-plug of PS08S switch panel (4) into your safety socket.
The occupation of the power-cord (3 x 2.5 mm²) is as follows: Brown live (L), Blue neutral (N), Green/Yellow earth (E).
The earth has to be connected always!
1. Reset button by overload current
2. Power on/off switches for channel 1-8
Output is via 8 safety power outlets. Connect your fixtures via the safety power outlets. The maximum current of all outputs are 15A/ 3.400Watt must
never be exceeded!
3. Power outlet channel 1-8
4. Power cable
Advertisement
