Advertisement
Available languages
Available languages
Installation Instructions
TURN OFF WATER SUPPLY
1. Close the main water supply valve, located
near the well pump or water meter.
2. Open all faucets to drain all water from
house pipes.
NOTE: Be sure not to drain water from the
water heater, as damage to the water heater
elements could result.
INSTALL THE BRINE TANK OVERFlOW
ADAPTER
Install the brine tank overflow grommet and
adapter in the 13/16" diameter hole in the back
of the salt storage tank sidewall, (see Figure 9).
NOTE: The brine tank overflow adapter accepts
either 1/2" or 3/8" I.D. hose.
INSTALL THE BYPASS VALVE
NOTE: For easier installation, remove the top
cover. Release 2 clips at rear of cover. Rotate
cover forward and lift up.
1. Visually check and remove any debris from
the water softener valve inlet and outlet
ports, (see Figure 7).
2. Make sure the turbine assembly spins freely
in the"out" port of the valve, (see Figure 8).
3. If not already done, put a light coating of
silicone grease (provided) on the single
bypass valve o-rings, (see Figure 7).
4. Push the single bypass valve into the
softener valve as far as it will go. Snap the
two large holding clips into place, from the
top down, (see Figure 7 and 10).
IMPORTANT: Be sure the clips snap firmly into
place so the single bypass valve will not pull out.
MOVE WATER SOFTENER INTO PLACE
WARNING
Excessive Weight Hazard
Use two or more people to move and install
water Softener Failure to do so can result in
back or other injury.
1. Move the water softener into the desired
location. Set it on a solid, level surface.
IMPORTANT: Do not place shims directly
under the salt storage tank to level the softener.
The weight of the tank, when full of water and
salt, may cause the tank to fracture at the shim.
Salt Cover
Brinewell
Cover
Brine
Tank
Stand
Tube
Brine
Valve
Assembly
NOTE: Unit is shown with top cover removed.
SINGLE BYPASS VALVE
CORRECT ASSEMBLY
Clip
Outside diameter of
water softener valve
inlet & outlet
NOTE: Be sure all 3 tabs of the clip go through the
matching holes on the water softener valve inlet or
outlet, and fully into the channel on the single bypass
valve. Make sure that the tabs are fully seated.
12
Nut - Ferrule
Float Stem
Figure 9
If connecting to floor
level plumbing, install
the bypass valve
turned downward, as
shown.
Outside diameter
of clip channel on
single bypass valve
Figure 10
Nozzle
Venturi
Assembly
Hole
Grommet
Brine Tank
Overflow
Adapter
Brine
Tubing
Brinewell
Advertisement
Chapters
