Leadway TKW19S User Manual page 6

7.5 Presetting call number setup
Setup presetting call number by sending the command in form of SMS through center number.
The number only can use mobile number.
Format : f1,mobile number#
Example : f1,13567832209#
7.6 SOS call number setup
Setup SOS call number by sending the command in form of SMS through center mobile phone NO. to the
terminal.
Can set three SOS number, Command:
sos1,11111111111#
sos2,22222222222#
sos3,33333333333#
Example: sos1,13412345678#
If the setting is successful, then reply "SOS set success!".
7.7 Cancel SOS call number
If you want to cancel SOS call number and don't remember the serial number you set before, you can send
query parameter condition message first to get the corresponding serial number. Secondly, you send cancel
SOS call number to the device. command in form of SMS through center mobile phone NO. to the
terminal.
Format: sos1 #
sos2 #
sos3 #
If the setup is successful, there will be a reply "SOS number delete successfully!".
7.8 Inquire parameter setting
Command: test#
Example: test #
Reply Message:
ver:TQ-v0.1-2013/07/04-22:51;ID:7893267561;ip:219.142.106.193;port:8500;center:13640927062;slave:1
3682431464;upload:65535s;work mode:1;bat level:3;GPS:OK(7);GPRS:OK(100);LED:OFF;
ver: firmware version
ID: 7893267561– device ID Number
ip: 219.142.106.193, PORT:8500 -- Server IP and port
center: Center number
slave: Slave center number
upload: GPRS Data upload interval
workmode: working mode
7.9 Work mode setup
m1,20
Command: # or m2,
working mode
The default
m1,20
#: mode 1, GSM and GSP always working, every 20 seconds send GPS data to server. (Range:
600
# or m3,20# or m4#
is mode 1,