Reproduction Prohibited
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
Note on Printed Wiring Boards :
•
Through hole is omitted.
•
: Pattern on the side which is seen.
Note on Schematic Diagram :
•
Use caution when replacing chip parts.
New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum capacitor,
because it is damaged by the heat.
All capacitors are in µF unless otherwise noted. pF : µµF 50 WV
•
or less are not indicated except for
•
All resistors are in
otherwise specified.
•
Chip resistors are 1/8 W or 1/10 W unless otherwise noted.
k
: 1000 , M
Note :
The components
identified by mark
dotted line with mark
are critical for safety.
Replace only with part
number specified.
All manuals and user guides at all-guides.com
PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
electrolytics
and tantalums.
and 1/4 W (Chip resisters : 1/10w) unless
: 1000 k .
Note :
Les composants identifies par
or
une marque
sont critiques
!
!
pour la securite.
!
Ne les remplacer que par une
piece portant le nubero specifie.
SECTION 6
— 7 —
SCPH-9000
SERIES