Advertisement
Using Your Kambrook Tower Fan
Before first use
Remove your tower fan from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Once assembled by following the
directions below, place the tower
fan on a firm, level surface in a stable
upright position. Visually inspect the air
inlet and outlets to ensure no foreign
material is blocking these areas.
WARNING: When
Unpacking the fan, check
to see you have received
all the items listed in
the parts list, before
discarding the packaging.
Assembling Your Kambrook
Arctic Tower Fan
To assemble the base stand;
1.
The tower fan base stand comes
in two separate pieces that are to
connect with one another.
2.
To assemble the base stand,
place the tower fan body on
its side. Remove the 4 fastening
screws from underneath the
tower fan section of the fan and
set aside. (See Fig. 1).
8
3.
Holding base stand piece (a)
with the curved side facing
towards the bottom part of the
tower fan body, position base
stand piece (a) screw posts over
the corresponding screw posts
located underneath the tower
fan body. Firmly push down base
stand piece (a) to set into place.
(See Fig. 2). Secure base stand
piece (a) with 2 of the fastening
screws. (See Fig. 3).
Fig. 1
a
Fig. 2
Fig. 2
a
Fig. 3
Fig. 3
Advertisement
