HP Compaq NX6310 Install Manual page 7

8) Open the c:\xpcd\i386\txtsetup.sif file in Notepad.
9) Go to the end of the file. There will be several blank lines.
10) Move the cursor up a few lines. This is necessary because there is a hidden marker at the end
of the file.
11)
Add the following lines
[SourceDisksFiles]
iastor.sys= 1,,,,,,4_,4,1,,,1,4
iaAHCI.cat=1,,,,,,,20,0,0
iaAHCI.inf=1,,,,,,,20,0,0
iaSTOR.cat=1,,,,,,,20,0,0
iaSTOR.inf=1,,,,,,,20,0,0
[HardwareIdsDatabase]
PCI\VEN_8086&DEV_27C5&CC_0106 = "iaStor"
PCI\VEN_8086&DEV_27C3&CC_0104 = "iaStor"
PCI\VEN_8086&DEV_27C1&CC_0106 = "iaStor"
PCI\VEN_8086&DEV_2652&CC_0104 = "iaStor"
PCI\VEN_8086&DEV_2652&CC_0106 = "iaStor"
PCI\VEN_8086&DEV_2653&CC_0106 = "iaStor"
PCI\VEN_8086&DEV_24DF&CC_0104 = "iaStor"
PCI\VEN_8086&DEV_25B0&CC_0104 = "iaStor"
[SCSI.Load]
iaStor = iaStor.sys,4
[SCSI]
iaStor = "Intel(R) 82801 SATA RAID/AHCI Controller
(ICH5,6,7)"
12) Save the file and exit notepad.
13) Extract the files from c:\xpcd\support\tools\deploy.cab to c:\deploytools
14) Create a new winnt.sif:
a. Execute setupmgr.exe (extracted from deploy.cab in step 13).
b. Select "Create new answer file"
c. Select "Unattended Setup"
d. Select "Windows XP Pro"
e. Select "User Interaction desired"
f. Select "Set up from a CD"
g. Enter desired information under each of the following Settings sections
h. Save the file as c:\xpcd\i386\winnt.sif
15) Open the c:\xpcd\i386\winnt.sif in notepad
16) Under the section [Unattended], add the following lines:
OemPreinstall=yes
OemPnPDriversPath=drivers\sata
DriverSigningPolicy = Ignore
17) Save winnt.sif and close notepad
18) Burn the custom XPCD from the c:\xpcd folder.
a. Note that the volume label of the CD must be the same as from the original XP CD
7