Table of Contents
Advertisement
AUDIO IN
Listen through a headphone
•
Plug a headphone (not supplied) into the
socket.
Update firmware
Warning
•
Always connect the speaker to AC power for firmware
upgrade.
•
Never power off the speaker or unplug the USB mass
storage device before completion of the firmware
upgrade.
Note
•
Make sure that the USB stick is FAT16/32 formatted.
1
On your PC/Mac, go to
www.philips.com/support.
2
Enter the model number to find the latest
firmware upgrade files available.
www.philips.com/support
3
Unzip and save the upgrade files to the
root directory of a USB stick.
4
Press USB to select the USB source, then
plug the USB stick into the USB socket on
the back of the speaker.
5
Do not remove the USB stick, and wait for
around 3 to 4 minutes for completion of
the firmware upgrade.
» During firmware upgrade, 'UPGRADE'
is shown on the display panel.
» At completion of firmware upgrade,
'SUCCESS' is shown on the display
panel.
6
Disconnect the AC power of the speaker
and remove the USB stick.
7
Connect AC power again and turn on the
speaker.
Tip
•
At completion of upgrade, remember to delete the
upgrade files from your USB stick.
EN
15
Advertisement
Table of Contents
