If it is necessary to replace the display bezel, display inverter, or display hinges, remove the eight
9.
rubber screw covers (1) and the eight Torx T8M2.5×6.0 screws (2) that secure the display bezel to
the display assembly. The rubber screw covers are available in the Rubber Kit, spare part number
456616-001.
Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display
10.
bezel until the bezel disengages from the display enclosure.
Remove the display bezel (3). The display bezel is available using spare part number
11.
456620-001.
If it is necessary to replace the display inverter, remove the inverter (1) from the display enclosure
12.
as far as the display panel cable and the backlight cable will allow.
Component replacement procedures
51