Switch cover
Description
Switch cover (includes LED board and cable)
Before removing the switch cover, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the keyboard (see
5.
Remove the switch cover:
Turn the computer upside down, with the rear panel toward you.
1.
Remove the two Torx T8M2.5×7.0 screws (1) and the two Torx T8M2.5×3.0 broad-head screws
2.
(2) that secure the switch cover to the computer.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as possible.
4.
Release the ZIF connector to which the LED board cable (1) is attached, and disconnect the cable
5.
from the system board.
Battery on page
34).
Keyboard on page
43).
Spare part number
456592-001
Component replacement procedures
45