LG 55LV35A-5B.AUS Easy Setup Manual page 21

Setting the Picture ID
The Picture ID menu allows you to control all sets using the IR Receiver connected to Set 1.
The IR signal of the remote control is
y y
transmitted through the RS232C cables
connected in serial mode.
When you set a Picture ID using the remote
y y
control, you can only control the Set that
matches the Picture ID.
ex) For example, if you set a Picture ID to 2,
you can only control the monitor with the
AUDIO
(RGB/DVI)
RS-232C OUT
Set ID 2.
If Picture ID is set to Off, you can control
RS-232C IN
REMOTE
all monitors at the same time.
CONTROL IN
2 x 2 Multi-Vision
IR Receiver
RS-232C
1
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
2
Picture ID
◄ Off ►
Close
Press the red ON button Von the remote control
to assign the Picture ID.
To change the Picture ID, press the ON button,
or the left and right arrow buttons continuously.
Picture ID
Off
◀
Close
NOTE
For example, if the Picture ID is assigned to
y y
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
For each set, you can change the settings
y y
for the PICTURE, TIME, NETWORK and MY
MEDIA menus or the hot keys on the remote
control.
If you press the green OFF button for
y y
Picture IDs, the Picture IDs for all sets are
turned off. If you then press any button on
the remote control, all sets will start working
again.
Picture ID will be disabled while using the
y y
MY MEDIA menu.
If Picture ID is set to Off, holding buttons
y y
on the remote control will execute only one
action at a time.
21
INSTALLATION
▶