Advertisement
RECEIVER PROGRAMMING
SYSTEM SETUP
Note: Transmitting devices such as cellular phones and two-way radios
may interfere with wireless audio transmissions. Keep your transmitters
and receivers away from these and other potential sources of
interference.
1. Turn on receiver. LCD will light.
2. Channel A set up
Group Selection
1. Press CH-A "MENU" button to move cursor to
"GROUP SELECT".
2. Press CH-A "SELECT" button to increase the
group number by one.
3. When the correct group is displayed, either wait
five seconds for the screen to time out, or press
CH-A "SYNC" button.
Channel Selection
1. Press CH-A "MENU" button again to move cursor
to "CHANNEL SELECT" .
2. Then press CH-A "SELECT" button to increases
the channel number by one.
3.When the correct channel is displayed, either wait
five seconds for the screen to time out, or press
CH-A "SYNC" button.
Automatic Transmitter Setup
1. Turn on the first transmitter.
2. Open transmitter battery cover to display the infrared (IR) port.
3. Point transmitter IR port to receiver IR sensor.
4. Press "SYNC" button on receiver. CH-A
antenna signal will display in receiver screen.
Now channel A is ready.
5. Close the transmitter battery cover.
3. Channel B set up
Follow the same steps as described in step 2, press CH-B buttons
to set up Channel B.
Be sure that only one transmitter IR port is exposed when
synchronizing a system.
-4-
Advertisement
