Making Individual Calls (Nxdn/ Dmr); Receiving - Kenwood NX-1200AV User Manual

Making Individual Calls (NXDN/ DMR)

You can select a Unit ID/ name from the list to make a call to those parties on a
channel.
1 Press the button programmed as [Individual], [Individual + Short Message]
or [Individual + Status] to enter Individual Call Mode.
Alternatively, press the button programmed as [Menu] to enter Individual
•
Call Mode using the Menu Mode.
• The ID list appears on the display.
2 Press the [ <B ] and [ C> ] buttons to select a Unit ID/ name from the list that
has been programmed into your transceiver.
3 Press and hold the PTT switch to make the call.
• The " " indicator blinks. The ID name of the target transceiver are
displayed.
• Speak to the microphone as you would during a normal call.

RECEIVING

1
Select the desired zone and channel. (If the Scan function has been
programmed, you can switch it On or Off as desired.)
2
When you hear the caller's voice, readjust the volume as necessary.
• If signaling has been programmed on the selected channel, you will hear a
call only if the signaling matches the signaling set up on your transceiver.
Refer to "OPTIONAL SIGNALING" {p. 75} for details.
• In Site Roaming zones, the transceiver will automatically search for the
strongest signal and receive on that frequency.
Note:
◆ A ringing tone will sound when receiving a call if the alert tone has been
enabled in the Alert Tone setting. For details, consult your dealer.
14