Makita LS004GD201 Instruction Manual page 27

Holders
WARNING:
Always support a long workpiece
so it is level with the top surface of the turn base
for an accurate cut and to prevent dangerous loss
of tool control. Proper workpiece support will help
avoid blade pinch and possible kickback which may
result in serious personal injury.
WARNING:
Before the cutting operation,
always be sure that the holders are secured by
the screws.
To hold long workpieces horizontally, holders are pro-
vided on both sides of the tool. Loosen the screws and
extend the holders to the appropriate length for holding
the workpiece. Then tighten the screws.
1 2
► 1. Holder 2. Screw
When cutting, place the workpiece flat against the guide
fences.
► 1. Guide fence 2. Holder
Sub base
Optional accessory
so it is level with the top surface of the turn base
for an accurate cut and to prevent dangerous loss
of tool control. Proper workpiece support will help
avoid blade pinch and possible kickback which may
result in serious personal injury.
always be sure that a sub base is secured by the
screw.
NOTE: For details on installation, follow the instruc-
tions provided with an optional sub base.
Install an optional sub base in the base to hold long
workpieces more securely. Loosen the screw and
extend the sub base to the appropriate length for hold-
ing the workpiece. Then tighten the screw.
1
► 1. Sub base 2. Screw
When cutting, place the workpiece flat against the guide
fence and the sub fence on the sub base.
1
2
► 1. Guide fence 2. Sub fence 3. Sub base
27 ENGLISH
WARNING:
Always support a long workpiece
WARNING:
Before the cutting operation,
2
1 2
3