Storing The Tool - Makita XCU10 Instruction Manual

Always fit a new locking ring when replacing the
sprocket.
1
► 1. Locking ring 2. Sprocket
NOTICE: Make sure that the sprocket is
installed as shown in the figure.

Storing the tool

1.
Clean the tool before storing. Remove any
chips and sawdust from the tool after removing
the sprocket cover.
2.
After cleaning the tool, run it under no load
to lubricate the saw chain and guide bar.
3.
Cover the guide bar with the guide bar
cover.
4.
Empty the oil tank.
2
20 ENGLISH