Connecting To An Av Receiver - Pioneer DV-290 Operating Instructions Manual

Connecting up
Watching progressive scan video
from the component video outputs
This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see Video Output settings on page 35.
When the player is set to output progressive
scan video, the PRGSVE indicator lights in the
front panel display.
Important
• When Component Out (page 35) is set to
Progressive, there is no video output from
the VIDEO OUT (composite) and S (S-
video) jacks.
• If you want to display video on more than
one monitor simultaneously, make sure
the player is set to Interlace.
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
the supplied video cable (see Easy
connections on page 11), then switch back
to Interlace (see below).
Switching the video output to interlace
using the front panel controls
Switch the player to standby then, using the
front panel controls, press
while pressing to switch the player back to
Interlace.
• DV-490V only: If the player is connected
using HDMI, disconnect the HDMI cable
before resetting the player to interlace
output. (If left connected, the HDMI output

Connecting to an AV receiver

To enjoy multichannel surround sound you
need to connect this player to an AV receiver
using the digital audio output.
In addition to a digital connection, we
recommend also connecting using the stereo
analog connection.
You'll probably also want to connect a video
output to your AV receiver. You can use any of
the video outputs available on this player (the
illustration shows a standard (composite)
connection).
STANDBY/ON
resolution will be reset to its default—see
Resetting the output resolution to the
default setting with HDMI connection on
page 15.)
STANDBY/ON
DV-490V
02
13
En