Display Assembly - HP 520 Maintenance And Service Manual

Display assembly

Description
14.1-inch, WXGA BrightView display assembly for use only with computer models with wireless LAN
capability (includes wireless antenna transceivers and cables)
14.1-inch, WXGA BrightView display assembly for use only with computer models without wireless
LAN capability
Before removing the display assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the memory/WLAN module compartment cover (see
5.
disconnect the wireless antenna cables from the WLAN module (see
Remove the following components:
6.
Switch cover (see
a.
Keyboard (see
b.
Remove the display assembly:
Close the computer and turn it upside down, with the rear panel toward you.
1.
Remove the two Phillips PM2.0×7.0 screws that secure the display assembly to the computer.
2.
Turn the computer display-side up, with the front toward you.
3.
Open the computer until the display assembly is in an upright position.
4.
Battery on page 31).
Switch cover on page
Keyboard on page 43)
Memory module on page
41)
Component replacement procedures
Spare part number
448328-001
448327-001
35) and
WLAN module on page 37).
45