Setting Channel Lock - HANNspree ST289MUB User Manual

1. Press the corresponding electronic equipment button. The indicator light will come
on for 2 seconds then it goes off; after 3 seconds, the indicator light will come on
again, showing that the setting mode has been entered.
2. While holding the electronic equipment button, press VOL+ twice consecutively to
assign volume lock to that electronic equipment (meaning the volume buttons will
only transmit code values to the assigned electronic equipment even under other
electronic equipment modes). The indicator light then goes off and setting mode is
exited.
3. While holding the electronic equipment button, press VOL- twice consecutively to
cancel volume lock under current mode (for example, if volume lock was set under
TV mode and you wish to transmit code values under current DVD mode, just
perform this unlock operation, while those electronic equipment modes not operated
still have volume locked up). The indicator light then goes off and setting mode is
exited.
4. During the setting process, releasing the electronic equipment button exits the
setting mode immediately without changing the status prior to setting.
5. Buttons other than VOL+/VOL- are not functional during search. Volume buttons
include VOL+, VOL- and MUTE.
6.1.5

Setting Channel Lock

Operating procedures are as follows:
1. Press the corresponding electronic equipment button. The indicator light will come
on for 2 seconds then it goes off; after 3 seconds, the indicator light will come on
again, showing that the setting mode has been entered.
2. While holding the electronic equipment button, press CH+ twice consecutively to
assign channel lock to that electronic equipment (meaning the channel buttons will
only transmit code values to the assigned electronic equipment even under other
electronic equipment modes). The indicator light then goes off and setting mode is
exited.
3. While holding the electronic equipment button, press CH- twice consecutively to
cancel channel lock under current mode (for example, if channel lock was set under
TV mode and you wish to transmit code values under current CABLE mode, just
perform this unlock operation, while those electronic equipment modes not so
operated still have channel locked up). The indicator light then goes off and setting
mode is exited.
39